Interface Cables       Analyzer Test Point Boards are divided into two sets of 64 points, each designed to mate with a 64 pin card edge connector. Dynalab uses card edge connections, rather than fine pitch, pin-type connectors, for durability and ease of use. A wide range of interface cables are offered to attach a Dynalab Circuit Analyzer to your test fixture.   Discrete Wire Interface Cable The Discrete Wire Interface Cable is the most commonly used interface cable. Its 64 individual 24 AWG wires are cut to length - ready to be attached to a fixture. This cable interfaces any Dynalab Analyzer and is available in two lengths.         5-2012   Discrete Wire Interface Cable, 12'       (Previous Part # 7110012)       5-2018   Discrete Wire Interface Cable, 18'       (Previous Part # 7110018)       Discrete Wire Connector To create custom interface cables, Dynalab offers the connector used to build the Discrete Wire Interface Cable. Note: Special crimping is required to attach wires to this connector.   5-2091   Card Edge Connector (Previous Part # 4000001) Home    ·     Products    ·     Support    ·     NX Series © 2004 Dynalab All rights reserved.