LED Guided Solutions
Applications that require illuminating fixture block cavities and corresponding storage bins for guided assembly can be accomplished with Dynalab LED Guided Test Point Boards. In addition, fixture boards dedicated to detecting mechanical items (clips, grommets, etc.) can also utilize these special test point boards.

There are three unique applications for the Dynalab LED Guided Test Point Boards:

Connector Pinning
Fixture Blocks that have LED’s actually located in the cavities to guide the operator where to insert the wire.
Application Note

Connector Pinning with Continuity

Electrical Fixture Blocks that have LED’s outside the connector opening to guide the operator where to insert the wire. Then the wire continuity is validated after assembly.
Application Note

Detection Switches

Fixture Blocks that verify the presence of a mechanical item and include an indicator LED
Application Note

LED Test Point Boards
In order to take advantage of the LED Guided function, a NX Tester needs to be equipped with LED Test Point Boards. LED Guided Test Point Boards and Standard Test Point Boards and cannot be installed in a NX Tester at the same time.

The LED Test Point Board can be purchased separately and installed in any existing NX Tester. Part Number: 5-4009

A new NX Tester can be purchased with the LED Test Point Boards installed. Specify a “-L” suffix when ordering. Example: 1-256-0-L

5-8825 Red LED with 6" leads  

5-8967 Power Supply, 5VDC, 4A